Almost finished with the remodel, soon it will be time to stuff the mattress in and head to the southwest! |
2022 was filled with many new adventures while camping, hiking, biking, kayaking, making new friends and visiting old friends. Travelling with the truck and camper all around Wisconsin, western Michigan, eastern Minnesota, Colorado, New Mexico, Arizona, and Utah provided plenty of time and experience to discover some flaws with the camper setup and find remedies to some of those issues. In late summer, in between trips, the planning and remodel began. Once complete, a final shake-down will be done before hitting the roads and trails again!
The Cabin
The first remodel of the front cabinets has been removed. The twin mattress was moved forward and placed up on a 1.5 inch raised deck to force tempered air under the bed and prevent issues during cold weather camping. A full rear divider wall was installed to establish a rear-access kitchen and separated location for the new Propex furnace and battery/charging unit. A small shelf table is positioned under the passenger side window between the rear wall and the side door.
Propex thermostat, 120v outlet with USB charger, Renogy battery monitor and remote 2000 watt inverter switch are on the back wall. |
A new electrical system was installed consisting of a 200Ah LiFePO4 lithium battery, 40 amp LiFePO4 smart-charger, a 12 fuse 12 volt panel, 2000 watt inverter, 30 amp 120 volt breaker panel, and 300 watt roof-mounted solar panels with expansion for 300 watts of remote panels. The battery and charger are now in the rear of the trailer because the tongue box where they were located conflicts with the truck's bumper mounted spare tire during truck/trailer articulation. New interior lights, exterior LED rock lights, and a 4" axle lift for the camper are under way.
For amateur radio items, I'm unsure exactly how and where the Yeasu FT-710 and connected computer will be mounted, but the monitor, keyboard and mouse will most likely be at the side table. The FT-710 can be remote-operated using the CQRlog software, however, the Yaesu FTM-7250 dual band will need to be within reach for use.
A cold air return routes air under the bed panel to prevent cold weather camping issues under the mattress. On the wall are three switches for interior and exterior lighting, and a 120v outlet. |
With the large tongue box removed, there may be room to mount two Scepter water cans flat against the front, and my fat bike above them! |
The Kitchen
Though not yet completed in this photo, this is the general layout of the kitchen. The battery, inverter, and solar charge controller are mounted to the left of the refrigerator. |
The trailer's rear double doors now open to a dedicated kitchen area that includes a cook stove and a split refrigerator/freezer, both on locking slides so they are very accessible. The Propex heater is mounted on the floor to the right of the refrigerator. Above the heater is a removable shelf for added kitchen storage. To the left of the refrigerator is a 200Ah battery, 40A charging unit, a 2000 watt inverter, the solar charge controller, the main battery shut-off and fuse block. Above the refrigerator is a full width shelf that holds the cook stove and storage areas on both sides.
Yeah, I think this will work just fine for what I want to do! |
Update
With most of the work done, the camper is now my home for the next several months. It's small, but it's very comfortable, but it suits my needs for a go-anywhere camper and radio shack. I'll mostly be in an RV park, but am planning several trips to do some POTA and SOTA stations, and do some remote boondocks camping.
No comments:
Post a Comment